June 2016 CERN Testbeam Logbook

Add Log

May 25 9:00 Starting Testbeam preparation at H6A beam area. Setup HSIO2 and updated Firmare.

-- Koji Nakamura - 2016-05-25

June 6 non-irrad sensor tuning start & done, Auto trigger data taking (3dut & 5tel) in beam line -> OK

-- Atlasj Silicon - 2016-06-06

June 6 22:47 check long auto trigger run (about 3h, 3dut & 5tel) -> telescopes & DUT are stable (don't stop run) by K.Sato

-- Atlasj Silicon - 2016-06-06

June 7 10:30 Updated firmware on Artex-7 of IFAE(AFP)'s HSIO2 (HsioCosmic _V11N_CosmicNew.bit) by H. Sawai

-- Atlasj Silicon - 2016-06-07

June 7 11:00 Started tuning for irrad-module by H. Sawai

-- Atlasj Silicon - 2016-06-07

June 7 19:36 Succeeded in remote controlling from the hut. Started 3SCC auto-trigger run with GeoID:31. by H. Sawai

-- Atlasj Silicon - 2016-06-07

June 7 23:47 Started run for 3SCC (no beam yet). GeoID:31, Run Number:1930~ by H. Sawai

-- Atlasj Silicon - 2016-06-07

June 7 23:52 All sensor tuning done by K.Sato

-- Atlasj Silicon - 2016-06-07

June 8 23:34 Adjusted position of 3 SCCs, and started run (Run Number:1950~) by H. Sawai

-- Atlasj Silicon - 2016-06-08

June 9 10:04 KEK105,106,108 connectivity check at control room, but tuning is not good...(connecivity is OK) so need to tune in beam line before test by K.Sato

-- Atlasj Silicon - 2016-06-09

<--/commentPlugin-->

More Information

-- Koji Nakamura - 2016-06-05