Line: 1 to 1 | ||||||||
---|---|---|---|---|---|---|---|---|
July 2019 DESY Testbeam log page | ||||||||
Line: 105 to 105 | ||||||||
14:30 install KEK53-13 & KEK53-17 in cooling box (*1) 15:30 tune modules | ||||||||
Added: | ||||||||
> > | 16:30 beam on -> KEK53-17 hitmap is no signal@-200V -> apply -400V -> hitmap can be seen and reveal bump peel off 18:00 KEK Batch5 run start | |||||||
YARR systemintroduction of YARR | ||||||||
Line: 158 to 162 | ||||||||
RD53A tuning finish!! | ||||||||
Changed: | ||||||||
< < | install module and setup (*1) | |||||||
> > | install 2 modules and setup (*1) | |||||||
how to install module in cooling box | ||||||||
Line: 177 to 181 | ||||||||
you can tune 2 module at the same time. this is how to do.
1. edit configs/connectivity/example_rd53a_setup.json | ||||||||
Changed: | ||||||||
< < |
| |||||||
> > |
| |||||||
| ||||||||
Changed: | ||||||||
< < | 2. $ ./primlist/scan53.sh digitalscan KEK1317 | |||||||
> > | 2. $ ./primlist/scan53.sh digitalscan KEK53-1317 | |||||||
| ||||||||
Changed: | ||||||||
< < |
| |||||||
> > |
| |||||||
| ||||||||
Added: | ||||||||
> > | 5. $ ./primlist/scan53a.sh noisescan
| |||||||
set producer, communicate with Run Control PCHow to set YARR producer | ||||||||
Line: 214 to 233 | ||||||||
How to tune RD53A by using BDAQ system | ||||||||
Changed: | ||||||||
< < | TLU tutrial | |||||||
> > | EUTelescope and TBmon2 tutrial | |||||||
install and setup software. please refer https://twiki.cern.ch/twiki/bin/view/Atlas/ITkPixelTestBeamReconstruction . |